Schluter Kerdi Board Washers (100/box)
Set up account and earn Learn more
- Schluter KERDI-BOARD washers are the required mechanical fastener component for attaching KERDI-BOARD panels to wood and metal stud framing — the large washer face distributes load across the board face to prevent the screw from pulling through
- Used in combination with KERDI-BOARD screws (sold separately or as a set); 100 washers per box; corrosion-resistant construction for use in wet areas
- Install one washer per screw; recommended fastener spacing is every 12" on stud faces and every 6" at panel edges; required for all KERDI-BOARD structural installations per Schluter installation guidelines
Couldn't load pickup availability
Description
Description
These are the KERDI-BOARD-ZT tab washers — the unsung hero of a clean KERDI-BOARD installation. If you already have screws but need more washers, or if you're replacing damaged fasteners, this 100-pack has you covered.
The washers are galvanized steel with small tabs that bite into the surface of KERDI-BOARD when pressed in, holding themselves in position while you drive the screw. That small detail saves a lot of frustration, especially working overhead or in tight corners. Vertical spacing: 12" (30 cm) o.c. Horizontal: 12" or 16" depending on stud layout.
Pro Tip: If you're ordering from scratch, grab the screw + washer combo sets (40 or 100 piece) — they're better value than ordering separately. But if you're mid-project and short on washers only, this box ships fast and gets you back on track. Don't substitute with regular flat washers — the tab grip is what keeps these from spinning while you tighten.
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.

